Eusso 5-Port Specifications

FCC Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Th

2.3.1.6 LINK LED (VDSL) If both ends of the VDSL devices are connected then the LED will blink for a while (in 10 seconds), this is the stage of spe

2.4 The Rear Panel The rear panel of the converter is shown below 2.4.1 Power Connecting Plug the circle end of the power adapter firmly in

3. Installing And Using Ethernet over VDSL Converter 3.1 Installing The Ethernet over VDSL Converter The converter does not require any softw

3.1.1 Connect to Internet Access Concentrator In order to build up a local Internet in apartment, hotel, campus and hospitality environment, the I

3.1.2.1 Station Connections with Telephone Wires 13Connect the network adapters in stations to the converter’s RJ-45 port through category 3, 4 or

4. Product Specifications Standard IEEE802.3 10BASE-T IEEE802.3u 100BASE-TX Ethernet over VDSL Interface 1 * 10/100Mbps Ethernet port 2 * RJ-11 conn

Table of Contents 1. Unpacking Information 2. Introduction To Ethernet over VDSL Converter 2.1 General Description 2.2 Key Features 2.3 The Fron

1. Unpacking Information Thank you for purchasing the Ethernet over VDSL converter. Before you start, please check all the contents of this package

2. Introduction To Ethernet over VDSL Converter 2.1 General Description The converter is a switching architecture with one RJ-45 10/100Mbps Eth

people do not need to access the services through Internet but using local area network with better bandwidth and efficiency. Meanwhile, this kind of

2.2 Key Features The converter provides the following key features: • Complies with IEEE802.3 10BASE-T standard • Complies with IEEE802.3u 100BAS

2.3 The Front Panel The front panel of the converter is shown below. Master Slave 2.3.1 LEDs definition The rich diagnostic LEDs on the front

2.3.1.3 100M LED (Ethernet) The RJ-45 port has a 100M LED. Steady green indicates that the port is operating at 100Mbps. If the LED is off, the link

LINK/ACT LED (Ethernet) Status Off No Connection Green 10/100Mbps 2.3.1.5 FDX/COL LED (Ethernet) A collision occurs when two stations within a col