Eusso UNC7702 User Manual download pdf (Page 50)

Appendix C

. How can I set factory default?

NS:

1. Unplug the power jack to turn off the power of UNC7702.

2. Insert a pin into the reset hole as circled with red in the below figures. Sense a button and keep

it pressed until instructed to release.

3. Plug in the power jack to turn on UNC7702, count 25 seconds (at least 20 seconds) and

release the button (remove the pin from the reset hole).

4. The UNC7702 should now be back to factory default. Have an access to the device by

changing to the attempt IP address from the default 192.168.0.200.

UNC770

Note:

1. When UNC7702 can be scanned by IPInstaller with this IP “192.168.0.200” after factory

setting, it means the reset process is successful.

2. Within the 20~25 seconds, the reset progress will be launched. If the inserted pin is removed

before 20 seconds or after 25 seconds, the system wouldn’t take any effect; the reset will be

unsuccessful. Redo from step 1 for another chance.

3. Do not remove power any time in the reset process, the flash memory inside the device can be

damaged otherwise.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55

No comments

Eusso UNC7702 User Manual Page 50